DIY kit is widely used in school electronics science education competitions, for learning about the basic knowledge of DIY soldering project, DC motor, mechanical, electronic science, sensor principle, automatic control etc. You can have a lot of fun and learning putting this robotics kit together and understanding the theory behind the way the Light Dependent Resistors detect the difference between the black of the line and the white of the area outside the line, if you’re helping a youngster put this kit together you can instruct them in reading the resistor codes or using a multi-meter to identify the ratings of the resistors so placement on the PCB is correct.
Widely Used in Science School Electronics Educational Competitions
- Smart tracking car is based on the principle of the light reflective difference, when light emitting on the white and black items, the red LED and photo-receptor as the sensing circuit to control the car running direction automatically, a photo-resistance resistance is used to tell robot car whether it’s on the right way or not, and run directly along the black tracking line.
- Motor: 2 pcs stepping motors, Tracking Line Width: 16 mm / 0.63 inch, you can use the 1.5~2.0 cm black electrical tape on the ground to design the multifarious runway. Power Supply: AA battery (not included).
Easy to Assemble and Soldering
It’s easy to assemble and solder, designed to help kids, electronic hobbyist and beginners to learn about basic knowledge of soldering simple circuits, photoelectric sensor circuit, voltage cooperator, motor driving, infrared sensor, C51 MCU, etc., teaching through lively activities, and inspire the interest in learning.
To practice this DIY soldering kit you may need the tools as following:
Soldering iron, Iron stand, Tweezers, Multi-meter, Diagonal cutting pliers, Long nose pliers, Screwdriver set, Solder sucker, Solder wire, Clean sponge…